Metra 99-7871 Specifications

INSTALLATION INSTRUCTIONS FOR PART 99-7871Small Flat Screwdriver • Phillips Screwdriver • Socket Wrench1-800-221-0932 www.metraonline.co

8FINAL ASSEMBLY1Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and ma

999-7871NOTES

99-7871 INSTRUCTIONS1-800-221-0932 www.metraonline.comREV. 04/21/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7871

Dash Disassembly Honda Civic 2006-2010... 1,2Kit Assembly: DIN Head Unit Provision

99-7871DASH DISASSEMBLYDisconnect the negative battery terminal to prevent an accidentalshort circuit.1Unclip and remove the panel belowthe steering w

99-7871DASH DISASSEMBLYUnclip and remove radio/climatecontrol assembly. (Figure E)6Remove the (2) Phillips screwssecuring the hazard switch to theradi

3NOTE: Secure the a/c vent, climatecontrol, hazard switch, and the pas-senger air bag on/off light into the99-7871 radio housing panel usingthe factor

4Snap the Trim plate into the RadioHousing. (Figure D)4ISO DIN HEAD UNIT PROVISION99-7871KIT ASSEMBLYNOTE: Secure the a/c vent, climatecontrol, hazard

5Attach the corresponding bracket tothe DDIN head unit. (Figure C)2CDRemove the center bar from the 99-7871 radio housing.(Figure B)1Insert the DDIN t

6Attach the corresponding bracket tothe (2) ISO head units. (Figure C)2D1Insert the DDIN trim plate into theradio housing. (Figure D)3Position the bra

7Slide the aftermarket head units intothe cages and secure. (Figure C)CSlide the DIN cages into the RadioHousing and secure by bending themetal lockin